VCAP-DCV Deploy Objective 3.4

blueprint, Networking, Troubleshooting, VCAP6-DCV Deploy, vDS, VSS
In this post we will continue to discuss VMware networking and now it time for troubleshoot a vSphere 6.x network implementation Here are the objectives from the blueprint that i am going to cover: Perform a vDS Health Check for teaming, MTU, mismatches, etc. Configure port groups to properly isolate network traffic Use command line tools to troubleshoot and identify configuration issues Use command line tools to troubleshoot and identify VLAN configurations Use DCUI network tool to correct network connectivity issue Lab Setup: Using VMware workstation: Microsoft Servers 2012R2 for Services (DNS , DHCP, etc…) installed esx0 Installed VCSA  Documents used: vSphere 6 Networking Guide vSphere Command-Line Interface Concepts and Examples Perform a vDS Health Check for teaming, MTU, mismatches, etc: To enable Health check on the vDS , click on…
Read More

VCAP-DCV Deploy Objective 3.2 – Part 2

blueprint, Networking, study guide, VCAP6-DCV Deploy, vDS, VSS
In this post we will continue to discuss how we Deploy and Manage a vSphere 6.x Network Infrastructure We are going to cover the following objective from the blueprint : Migrate a vSS network to a hybrid or full vDS solution Analyze vDS settings using command line tools Determine which appropriate discovery protocol to use for specific hardware vendors Configure VLANs/PVLANs according to a deployment plan Create / Apply traffic marking and filtering rules Lab Setup: Using VMware workstation: Microsoft Servers 2012R2 for Services (DNS , DHCP, etc…) installed esx0 Installed VCSA  Documents used: vSphere 6 Networking Guide   Migrate a vSS network to a hybrid or full vDS solution: Here are the steps and screenshots on how to migrate from vSS to vDS (I will not use screenshots for creation of…
Read More

VCAP-DCV Deploy Objective 3.1

blueprint, Networking, study guide, VCAP6-DCV Deploy, VSS
We are now in the third section of the blueprint , this section is the Networking part and in the following posts we are going to discuss how we Deploy and Manage a vSphere 6.x Network Infrastructure We are going to discuss the following objective from the blueprint : Create and manage vSS components according to a deployment plan: VMkernel ports on standard switches Advanced vSS settings Configure TCP/IP stack on a host Create a custom TCP/IP stack Configure and analyze vSS settings using command line tools Lab Setup: Using VMware workstation: Microsoft Servers 2012R2 for Services (DNS , DHCP, etc…) installed esx0 Installed VCSA  Documents used: vSphere 6 Networking Guide Create and manage vSS components according to a deployment plan: To create vSS via the GUI click on the Host >>Manage>>Networking>> Virtual…
Read More